Teledyne LeCroy WaveAce EasyScope Operators Manual - Manual (Page 19)

EasyScope Operator's Manual
ES-OM-E-RevA 19
Setting Pass/Fail Ranges
The WaveAce series oscilloscope can automatically measure 32 parameters. You can set the Pass/Fail ranges
for each of these measurements.
1. To set pass/fail ranges, in the Wave Measure window click the Pass/Fail button. The Pass/Fail setting
window opens.
2. Click the drop-down arrow to select a measure type, such as Vpp, Vmax, Vmin, etc. and click the Enable
checkbox.
3. Under Pass Range Settings, type a minimum and maximum limit.
Note: The limits must be between -999 and 999.
2. Click OK.