Gilderfluke&Co Pb-DMX - Manual (Page 22)

tions. With this flag set, it is possible to set a sequence of shows playing in any order.
Since the ʻnextʼ show can be any show you ask for, one show can be played over and
over again, or you can set up a sequence of shows which will be repeated until the Pb-
DMX/32 is told to stop.
Unlike most Gilderfluke products, the addressed version of this command for the Pb-
DMX/32 is fixed at ʻ00ʼ. This is why the address in this command is ALWAYS ʻ00ʼ.
Stop at End Track ʻ%00ʼ
Stop at End Global ʻ&ʼ
These commands reset the ʻLOOPING SHOWSʼ flag in the selected BR-
MultiBrick32(s). What this does is to stop them playing when the end of the current
show is reached. These commands are used when you want the shows to finish grace-
fully. The STOP commands are used when you want to stop a show immediately.
Unlike most Gilderfluke products, the addressed version of this command for the Pb-
DMX/32 is fixed at ʻ00ʼ. This is why the address in this command is ALWAYS ʻ00ʼ.
Select Show Track ʻ)00ʼ (show#)
Select Show Global ʻ*ʼ (show#)
Up to two hundred fifty-five different animated shows can be stored on a single Pb-
DMX/32. This command can be used to select an individual show on the selected Pb-
DMX/32. Individual shows can be requested using Hexadecimal numbers with a range
of 01 to FF. Once a show is selected, it will be played on the next serial port START or
LOOP command. If a show is currently ʻloopingʼ, the requested show will be played at
the end of the next ʻloopʼ.
If a show selection has been made inadvertently, it can be cleared by sending a re-
quest for show number ʻ00ʼ.
Unlike most Gilderfluke products, the addressed version of this command for the Pb-
DMX/32 is fixed at ʻ00ʼ. This is why the address in this command is ALWAYS ʻ00ʼ.
Pause Show ʻ<00ʼ
Continue Show ʻ>00ʼ
Any show can be paused at any point during its playback. The outputs are frozen at
the levels they were at the instant the PAUSE command is received.
The CONTINUE command will resume playing any show playing which has previ-
ously been PAUSED.
Unlike most Gilderfluke products, the address for the Pb-DMX/32 is fixed at ʻ00ʼ.
This is why the address in this command is ALWAYS ʻ00ʼ.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Pb-DMX/32 v1.+ Manual / 10/31/13 / page 16 of 37