SecurityMan SmartCamDVR - User manual User Manual
Page 30
Blue status indicator
26
When disabling motion detection video recording, the indicator light will
turn blue and the SmartCamDVR will beep 5 times if there are any new
events recorded and beep 1 time if there were no new events recorded.
IMPORTANT NOTICE: If motion is still being detected after the 15 second
time frame the SmartCamDVR will continue to record using the same file
until it reaches the 15 minute max mark. At this time a new event will be
generated and the recording will continue if the movement persists.
When motion is detected, the indicator light will flash blue and stay solid
green to indicate that the camera is recording. Motion Detected video
recording records in increments of 15 seconds per even with a 3 second
“pre-alarm” recording totaling the total time per video clip to 18 seconds.
To
STOP (disable) motion detection recording, press the motion detection
button
located on the back of the SmartCamDVR or the
TRIGGER
OFF button on the RC (remote control) at any time as illustrated below.