SecurityMan SmartCamDVR - User manual - Manual (Page 28)

(Video Mode)
24
In motion detection photo mode, the green indicator light will stay solid
and flashes blue three times to indicate motion detection photo recording
and then changes back to green for stand-by. To
STOP (disable) motion
detection recording, press the motion detection button located on
the back of the SmartCamDVR or the TRIGGER OFF button on the RC
(remote control) at any time. When disabling motion detection recording,
the indicator light will turn blue and the SmartCamDVR will beep 5 times
if there are any new events recorded and beep 1 time if there were no new
events recorded.
NOTE: The SmartCamDVR will take 3 consecutive snap shots “Per Motion
Detection Event” in “Photo” mode and will beep 5 times when disarming
to indicate that there are new events recorded.
Video Recording by Motion Detection
To start recording video based on MOTION DETECTION, move the event
type switch to “ VIDEO” as illustrated below.