SecurityMan SmartCamDVR - User manual - Manual (Page 12)

8
Buttons Description:
REC: Press to initiate manual recording.
STOP: Press to stop manual recording.
TRIGGER ON: Press to enable motion detection mode.
TRIGGER OFF: Press to disable motion detection mode.
When using the remote control, please make sure to connect the IR
EXTENSION cable or the Remote Control Receiver cable (included) to the
IR EXTENSION port and make sure the IR receiver module at the end of
the receiver cable is pointing towards the remote control.
Press the REC or TRIGGER ON buttons to activate manual recording
or motion detection recording accordingly. During activation, the
SmartCamDVR will beep twice giving an audible notification that the
recording type has been successfully activated. Press the
STOP or
TRIGGER OFF buttons to disable manual recording or disable motion
detection recording. When disabling, the SmartCamDVR will beep once to
indicate that the recording type has been disabled.
Tips:
• The RC (remote control) uses infrared signal waves to communicate
with the receiver module by direct line of sight, please ensure objects
are not hindering when RC is in use.
• RC distance is 10m in direct line of sight, if the transmitting distance
gets shorter or looses accuracy, please replace the battery
• If the remote control is not in use please remove the battery from the
remote control to avoid circuit damage and conserve battery life.
• To replace or remove the battery; reference the diagram
illustrated at the back side of the RC.