Robertshaw 8601-1 - Manual (Page 7)

Programming Guide
SETTING TIME OF DAY AND
DAY OF WEEK
1. Press SELECT until the cursor is
over . Press SET. The HOURS
segment will be blinking. Use the
or button to adjust the
HOURS setting. NOTE: The AM or
PM indicator will change as the
HOURS display rolls through a 24
hour cycle.
2. Press SET. The MINUTES segment will be blinking. Use the or
button to adjust the MINUTES setting.
3. Press SET. The DAY segment will be blinking at the top of the
display. Use the or button to adjust the day of the week.
Press SET.
PROGRAMMING YOUR THERMOSTAT
The 8601 thermostat features 1-button programming. Simply follow these
steps to customize your thermostat for your lifestyle.
1. Place the HEAT-OFF-A/C switch into the
HEAT position. Make sure the cursor is in
the PROG position. Press SET. The
HOURS segment will be blinking. MON
thru FRI (the work week) will be displayed
across the top. AM1 will be illuminated in the lower right hand cor-
ner. You can now start programming the first event of the
work week.
2. Use the or button to adjust the hour of the first event. Press SET.
3. The MINUTES segment will be blinking. Use the or button to
adjust the minutes. Press SET.
4. The temperature should be blinking. Use the or button to
adjust the desired temperature of the first event. Press SET.
5. AM2 should now be displayed. Repeat
steps 2-4 to program the remaining events
(PM1 and PM2) for the work week. There
are a total of 4 events.
7
MON = MONDAY
TUE = TUESDAY
WED = WEDNESDAY
THU = THURSDAY
FRI
= FRIDAY
SAT = SATURDAY
SUN = SUNDAY
select set
hold
vac prog temp
MON
° F
a/c off heat on auto
select set
hold
vac prog temp
on
Cursor
110-1165 6/8/05 11:51 AM Page 7