Acer Altos R710 - Manual (Page 65)

53
Installing the SCSI 6th HD upgrade kit in Altos
R710
The SCSI sixth HD upgrade kit is used when a sixth SCSI hot-swap drive
is needed.
1.Power down the server and unplug all peripheral devices and the AC
power cable.
2.Remove the chassis cover.
3.Remove the front bezel if it is installed.
4.Remove the drive blank from the sixth drive bay by using a long
screwdriver to push it out through the front of the chassis.
Figure 1. Remove the Drive Blank from the Chassis
5.Remove the fan module.
6.Hold the SCSI sixth drive board about ?-inch above the opening in
the backplane to allow alignment notches to clear the top of the
backplane bracket. Move the board forward into the opening and set
it into place while lining up the two tabs on the sixth drive kit board
TP01366