Acer Altos R710 - Manual (Page 187)

175
5.Press and hold the left and right Slide Extension Release Levers
and slowly slide the component throughout its entire range of
motion to ensure that cabling is not strained or restricting
movement of Slide Rails. Make certain cabling is not pinched when
slides and CMA are in the fully retracted position.
General Safety Information
WARNING! WARNING statements indicate a possible hazard
which, if not avoided, could result in personal injury or death.
Caution! Caution statements indicate a problem or unsafe practice
which, if not avoided, could result in product or property damage.
Note: Note statements provide supplemental information.
WARNING !
• For complete safety and regulatory information, see your
System Information document.
• This Slide Rail kit is intended only for use with components of
1 RU or 2 RU height.
• Maximum component weight: 18.2 kg (40 lb.) for 1 RU; 38.6 kg
(85 lb.) for 2 RU.
• Installing components in a rack without the front and side
stabilizers could cause the rack to tip over. Always install the
stabilizers before installing components in the rack.
• Always load the rack from the bottom up. Load the heaviest
component in the rack first in the lowest position.
• When preparing to install a component in the rack, always
extend the Slide Rails into the locking position, and then slide
the component into the Slide Rail mounting positions.
• Use caution when pressing the Slide Rail release latches and
sliding the component in or out of the rack; the Slide Rails can
pinch your fingers.