Acer Altos R710 - Manual (Page 159)

147
Hardware Diagnostic Testing
This section provides a more detailed approach to identifying a
hardware problem and locating its source.
Caution: Turn off devices before disconnecting cables:
Before
disconnecting any peripheral cables from the system,
turn off the system and any external peripheral
devices. Failure to do so can cause permanent
damage to the system and/or the peripheral devices.
1 Turn off the system and all external peripheral devices. Disconnect
each device from the system, except for the keyboard and the
video monitor.
2 Make sure the system power cord is plugged into a properly
grounded AC outlet.
3 Make sure your video display monitor and keyboard are correctly
connected to the system. Turn on the video monitor. Set its
brightness and contrast controls to at least two thirds of their
maximum ranges (see the documentation supplied with your video
display monitor).
4 If the operating system normally loads from the hard disk drive,
make sure there is no diskette in drive A and no CD-ROM disk in
the CD-ROM drive.
5 If the power LED does light, attempt to boot from a floppy
diskette or from a CD-ROM disk.
6 Turn on the system. If the power LED does not light, see “Power
Light Does Not Light.”
Verifying Proper Operation of Key System Lights
As POST determines the system configuration, it tests for the presence
of each mass storage device installed in the system. As each device is
checked, its activity light should turn on briefly. Check for the
following:
• Does the diskette drive activity light turn on briefly? If not, see “Diskette
Drive Activity Light Does Not Light.”Diskette Drive Activity Light Does Not
Light
• If system LEDs are illuminated, see LED Information“” for a description of