Teledyne 3020M - Explosion proof paramagnetic oxygen analyzer - Manual (Page 34)

3 Installation Model 3020M
3-12 Teledyne Analytical Instruments
3.4 Gas Connections
Figure 3-9 is an illustration of the Gas Connector Panel. Optional gas
connections are shown in shaded blocks.
The unit is manufactured with 1 /
4
inch tube fittings only. Adapters must
be used for metric tubing. (At least 6 mm is recommended.)
For a safe connection:
1. Insert the tube into the tube fitting, and finger-tighten the nut until
the tubing cannot be rotated freely, by hand, in the fitting. (This
may require an additional
1 /
8
turn beyond finger-tight.)
2. Hold the fitting body steady with a backup wrench, and with
another wrench rotate the nut another 1 1 /
4
turns.
Figure 3-9: Gas Connector Panel
SAMPLE IN: In the standard model, gas connections are made at the
SAMPLE IN and EXHAUST OUT connections. Calibration gases must be
Tee'd into the Sample inlet with appropriate valves.
SCCM