Accton Technology ES3526XA - Manual (Page 473)

Multicast Filtering Commands
4-231
4
Command Usage
Enter this command without any keywords to display the global settings for
MVR. Use the interface keyword to display information about interfaces
attached to the MVR VLAN. Or use the members keyword to display
information about multicast groups assigned to the MVR VLAN.
Example
The following shows the global MVR settings:
The following displays information about the interfaces attached to the MVR VLAN:
Console#show mvr
MVR Status:enable
MVR running status:TRUE
MVR multicast vlan:1
MVR Max Multicast Groups:255
MVR Current multicast groups:10
Console#
Table 4-74 show mvr - display description
Field Description
MVR Status Shows if MVR is globally enabled on the switch.
MVR running status Indicates whether or not all necessary conditions in the MVR environment
are satisfied.
MVR multicast vlan Shows the VLAN used to transport all MVR multicast traffic.
MVR Max Multicast Groups Shows the maximum number of multicast groups which can assigned to the
MVR VLAN.
MVR Current multicast groups Shows the number of multicast groups currently assigned to the MVR VLAN.
Console#show mvr interface
Port Type Status Immediate Leave
------- -------- ------------- ---------------
eth1/1 SOURCE ACTIVE/UP Disable
eth1/2 RECEIVER ACTIVE/UP Disable
eth1/5 RECEIVER INACTIVE/DOWN Disable
eth1/6 RECEIVER INACTIVE/DOWN Disable
eth1/7 RECEIVER INACTIVE/DOWN Disable
Console#
Table 4-75 show mvr interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for source ports is
“ACTIVE” if MVR is globally enabled on the switch. MVR status for receiver
ports is “ACTIVE” only if there are subscribers receiving multicast traffic from
one of the MVR groups, or a multicast group has been statically assigned to
an interface.
Immediate Leave Shows if immediate leave is enabled or disabled.