Accton Technology ES3526XA - Manual (Page 299)

System Management Commands
4-57
4
ntp client
This command enables NTP client requests for time synchronization from NTP time
servers specified with the ntp servers command. Use the no form to disable NTP
client requests.
Syntax
[no] ntp client
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• The SNTP and NTP clients cannot be enabled at the same time. First disable
the SNTP client before using this command.
• The time acquired from time servers is used to record accurate dates and
times for log events. Without NTP, the switch only records the time starting
from the factory default set at the last bootup (i.e., 00:00:00, Jan. 1, 2001).
• This command enables client time requests to time servers specified via the
ntp servers command. It issues time synchronization requests based on the
interval set via the ntp poll command.
Example
Related Commands
sntp client (4-54)
ntp poll (4-58)
ntp server (4-57)
ntp server
This command sets the IP addresses of the servers to which NTP time requests are
issued. Use the no form of the command to clear a specific time server or all servers
from the current list.
Syntax
ntp server ip-address [version number] [key key-number]
no ntp server [ip-address]
• ip-address - IP address of an NTP time server.
• number - The NTP version number supported by the server. (Range: 1-3)
• key-number - The number of an authentication key to use in
communications with the server. (Range: 1-65535)
Console(config)#ntp client
Console(config)#