Accton Technology ES3526XA - Manual (Page 338)

Command Line Interface
4-96
4
Command Mode
Interface Configuration
Command Usage
The maximum number of MAC addresses per port is 1024, and the maximum
number of secure MAC addresses supported for the switch system is 1024.
When the limit is reached, all new MAC addresses are treated as
authentication failed.
Example
network-access mac-filter
Use this command to define MAC address filters for network access. The MAC
address filters are used to specify MAC addresses to be excluded from network
access authentication. Use the no form of this command to remove existing MAC
address filters.
Syntax
[no] network-access mac-filter filter-id mac-address
• filter-id - The number that identifies the filter. (Range: 1-64)
• mac-address - A MAC address to be excluded from authentication. (Must
be in the format: xx-xx-xx-xx-xx-xx.)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Enter this command more than once with the same filter ID to add multiple
MAC addresses to a filter.
• Once created, filters must be applied to a port interface using the
network-access port-mac-filter command. Only one filter can be applied to
a port.
• MAC addresses in a filter are not authenticated by a RADIUS server when
seen on a port, the addresses are immediately added to the secure MAC
address table.
Console(config-if)#network-access max-mac-count 5
Console(config-if)#