Diamond Products CC1300XL - Manual (Page 29)

CC1200-CC1300XL Concrete Saw Manual 25
ring into the groove at the front of the wheel
shaft to secure the wheel (CC1300XL).
7. Repeat steps 2–6 to replace the second wheel.
Rear Wheels
Inspect the rear wheels regularly for damages or
wear and replace as necessary.
Figure 24: CC1200 Rear Wheels
1. Remove the setscrews from the set collar.
2. Remove the set collar and wheel from the
wheel shaft.
3. Place a new wheel onto the wheel shaft and
slide it to the back of the shaft. Note: Make sure
the spacer washer is behind the wheel
(CC1200)
4. Place the set collar up against the wheel on the
wheel shaft.
.
5. Tighten the setscrews into the set collar to
secure the wheel.
6. Repeat steps 1–5 to replace the second wheel.
Blade Drive Belts
WARNING
• Turn off the engine prior to
performing belt maintenance.
CAUTION
• Always let the belts cool down prior to
performing belt maintenance.
Note: Over-tensioning the belts may damage the
engine crankshaft. Under-tensioning the belts may
cause shorter belt life and/or poor saw
performance. Squealing belts indicate looseness
.
Figure 25: CC1300XL Belts
Tensioning the Blade Drive Belts
1. Inspect the belts for fraying, stress cracks,
and/or breakage and replace immediately when
damaged.
2. Test the belt tension. Proceed to step 3 if the
belts need tensioning (refer to the Belt Tension
Settings in the Index for proper tension setting).
Operate the saw as needed if no tension
adjustments are required.
3. For engines without the adapter plate or
adapter mounts; there are four screw/nut
assemblies securing the engine/motor to the
frame through the frame slots. Loosen the nut
on each screw.
4. For engines with the adapter plate or adapter
mounts; there are four screw/nut assemblies
securing the adapter plate or adapter mounts to
the frame through the frame slots. Loosen the
nut on each screw.