Diamond Products CC1300XL - Manual (Page 25)

CC1200-CC1300XL Concrete Saw Manual 21
Making a Cut
1. Turn on the water valve. Note: Always have a
proper water pressure and flow when cutting
2. Align the blade and front pointer with the cutting
line.
.
3. Lower the blade into the concrete slowly. DO
NOT cut any deeper than required. Use the
depth indicator (CC1200) as a reference to
determine the blade’s depth when cutting.
4. Push the saw forward, at a proper speed, to
continue down the cutting line. Cut as fast as
the blade allows; if the blade climbs out of the
cut reduce the forward speed and/or cutting
depth. Raise and lower the blade as necessary
while cutting.
Continuing a Partial-Cut
1. Align the blade with the previous cut and lower
the blade back into the cut (using the depth
indicator (CC1200) as necessary). DO NOT
move forward unless the blade is properly
aligned within the cut.
2. Push the saw forward, at a proper speed, to
continue down the cutting line. Raise and lower
the blade as necessary while cutting.
Finishing a Cut
1. Stop the saw.
2. Raise the blade from the cut (high enough for
proper ground clearance).
3. Turn off the water valve.