Blade guard, Installing the blade guard, Removing the blade guard – Diamond Products CC1300XL User Manual

Page 20

4. Carefully remove the outer flange from the inner

flange alignment pinhole and blade, and then
remove the flange from the blade shaft.

5. Remove the blade from the blade shaft. Place

the blade in an appropriate storage location.

6. Inspect the nut/screw, outer flange, and inner

flange for damages and clean, repair, or
replace as necessary.

7. Fit the outer flange back onto the blade shaft.
8. Fit the blade shaft screw into the threads in the

blade shaft (CC1200). Fit the blade shaft nut
onto the threads on the blade shaft
(CC1300XL). Tighten the nut/screw by hand to
secure the inner and outer flange together.

9. Replace the blade guard or pivot the front of the

guard down and over the blade to secure.

Blade Guard

WARNING

• DO NOT operate the saw with the blade

guard raised or removed.

• DO NOT remove the blade guard with the

engine running.

• Blade exposure should not exceed 180°

while cutting.

• Always pivot the front of the

blade guard 180° (fully
upward) so the guard does
not swing back unexpectedly,
which may cause serious injuries.

The blade guard shields the blade and must always
be in place when operating the saw. Inspect the
blade guard and its water tubes prior to starting the
saw. Clean, repair, or replace damaged
components immediately. Note: Always use a blade
guard that corresponds with the blade size

Installing the Blade Guard

1. Face the front of the blade guard forward and fit

the tapered mount on the side of the guard over
the tapered blade guard mount on the frame.

Figure 14: Lowering the Guard

2. Insert the lock pin through the matched up

holes on the blade guard and the tapered blade
guard mount to secure the guard (CC1200).

3. Connect the water supply hose to the blade

guard.

Figure 15: Connecting the Hose

Removing the Blade Guard

1. Disconnect the water supply hose from the

blade guard.

2. Remove the lock pin from the blade guard

(CC1200).

3. Use the handle on the blade guard to rock the

guard back and forth while lifting the guard off
of the tapered mount.

This manual is related to the following products:

CC1200