Diamond Products CC1300XL - Manual (Page 11)

CC1200-CC1300XL Concrete Saw Manual 7
Controls
Figure 3: Control Panel
Figure 4: Electric Motor Starter Boxes
Controls Shown Above:
1. Handwheel–Raises/lowers saw and blade.
2. Index Plunger–Locks/unlocks handwheel.
3. Throttle Lever–Increases/decreases engine
speed.
4. Stop Pushbutton–Stops engine (engine switch
must be off to stop engine permanently).
5. On/Off Lever–Starts/stops electric motor.
6. Stop Pushbutton–Stops electric motor.
7. Start Pushbutton–Starts electric motor.
8. Ammeter–Indicates electric motor’s load while
cutting.
Controls not Shown Above:
1. Water Valve–Controls water flow to blade.
2. Engine/Stop Switch–Actuate in order to
start/stop engine.
3. Recoil Starter–Starts engine.
4. Choke–Restricts air flow in carburetor when
starting cold engine.
5. Fuel Tank Cap–Opening to add fuel.
6. Fuel Shutoff Lever–Opens/closes fuel line.
Note: Each control applies to certain saw models
.
1
2 3
4
8
5
6
7