Micromod RetroPAK: MOD 30 Installation Manual - Manual (Page 12)

MOD 30ML Replacement for MOD 30 Instruments
PRODUCT DESCRIPTION
1.4.2 2006A Nonisolated Digital Input Module
The Nonisolated Digital Input Module accepts switch contact closures without external
power requirements. It is functionally equivalent to a digital input circuit in a MOD 30
instrument. This module uses the Digital Input Module (DIM) Block for configuration of
input parameters.
DIM
Catalog Number Description for 2006A
BASE NUMBER
2006A Nonisolated Digital Input Module
UNUSED Z Unused Character
ELECTRICAL CODE 10 General Purpose, Kent-Taylor standard
3
4
5
2
1
INPUT RANGE 10 2.2 V to 24 VDC
UNUSED 0 Unused Character
MODEL A Design Level
Sample Number 2006AZ10100A
1.4.3 2007A Nonisolated Digital Output Module
The Nonisolated Digital Output Module is primarily intended for instrument-to-instrument
signaling. The module interfaces 24-volt on/off signals with no isolation or works as an
open collector switch that also supports 5V TTL. This module uses the Digital Output
Module (DOM) Block for configuration of output parameters.
DOM
Catalog Number Description for 2007A
BASE NUMBER
2007A Nonisolated Digital Output Module
UNUSED Z Unused Character
ELECTRICAL CODE 10 General Purpose, Kent-Taylor standard
3
4
5
2
1
OUTPUT RANGE 10 24 V, 50 mA TTL
UNUSED 0 Unused Character
MODEL A Design Level
Sample Number 2007AZ10100A
8