Meriam M2110F SMART FLOW GAUGE - Manual (Page 7)

7
4 FRONT PANEL
Warning
All settings must only be entered by qualified personnel, paying particular attention to the safety and precautionary
warnings. Changes to the register settings may cause incorrect flow rate display values.
4.1 FLOW METER DISPLAY
4.1.1 Indicators
When the gauge is in the normal measurement mode of operation it will display the Flow Rate, Engineering Unit
and Time Base on the LCD display. The top of the display will show the following possible status indicators:
PRGM, SET1/SET2 or 4-20mA, which will be described below.
PRGM:
When the gauge is in Program Mode the display will illuminate the PRGM indicator, which prompts the user for
further keypad entry data.
SET1/SET2:
The SetPoint models will illuminate the SET1 or SET2 indicators to show active level sensing relay outputs. This
indicator is also used to indicate that the register that is being edited is used to configure the relay level sensing
function. These configuration registers include P5, P6 and P7 for the M2110F Relay Output Model.
4-20mA:
The Current Loop models will display the 4-20mA indicator when the 4-20 mA analog output is enabled or when
the user is editing the 4-20mA configuration register. These configuration registers include P5, P6, and P7 for the
M2110F Analog 4-20mA Output Model.
Decimal Point:
The decimal point is used to indicate the status of the Low Flow CutOff detection. If the Low Flow CutOff is active
the display will show a flashing decimal point.