Meriam M2110F SMART FLOW GAUGE - Manual (Page 33)

33
3.60 in.
(92mm)
3.60 in.
(92mm)
PANEL MOUNT
CUTOUT
14.3 OUTLINE DIMENSIONS
14.3.1 Panel Mounting
1. Make a ¼ DIN panel cutout per drawing.
2. Remove the two 6-32 socket head screws in
the grooves at the rear of the gauge.
3. Slide the panel mount jacks out of the groove.
4. Insert the gauge through the front of the panel.
5. From the rear, insert the panel mount jacks in
the grooves on the side of the gauge, and
slide them firmly against the panel.
6. Replace the two 6-32 socket head screws.
7. Tighten the panel mount jack against the panel
with the two socket head screws.
8. Refer to the note on page 30 when making
pressure connections.