MAX LM-380A - Manual (Page 59)

TROUBLE SHOOTING
59
Error message Contents Solution
INITIALIZE AFTER
DELETE ALL FILES
It was attempted to initialize the
setting while inputting a document.
Implement the initialization of setting
after deleting all documents.
NO INPUT FILE
It was attempted to print without a
file to be created.
Implement the print after inputting the
file.
OVER PRINTING
SIZE
The file to be printed is
overflowing from the print material
now editing.
Change number of lines, space
between lines or character size.
OVER PRINTING
LENGTH
The “PRINTING LENGTH” that
has been set is exceeded.
It is not possible to print beyond
“PRINTING LENGTH.”
OVER PITCH
LENGTH
The number of characters that
was inputted is not contained in
“PITCH LENGTH” that has been
set.
Change “PITCH LENGTH” or number
of characters to input.
OVER TOTAL PRINT
LENGTH
The length that can be printed at a
time is exceeded.
Tube: 20m
Tape: 5m
It is not possible to print beyond the
maximum “PRINTING LENGTH.”
Change the setting or print dividing
the range using the print range
setting.
NO PRINTED
MATERIAL
The consumable has not been set. Set the print material.
COVER IS OPENED
The cover was opened while
printing.
Printing is not possible when the
cover is open. Close it.
THERMAL HEAD IS
UNUSUAL
Printing cannot be performed
because the temperature of the
printer head has increased.
After leaving it for a while, print again.
ERROR IN HALF CUT
OPERATION
Printing cannot be performed
because the half cutter unit does
not operate normally.
Feed the printed material or replace
the half cutter unit.
CARD
UNIDENTIFIABLE
The compact flash card has not
been formatted normally.
Try the format again. Only “FAT12”
and “FAT16” format can be used.
NO CARD The card has not been set. Set the card.
OVER CAPACITY
The compact flash card does not
have vacant capacity.
Use a new card or delete
unnecessary files.
CANNOT RECALL
THIS FILE
It was attempted to read a file of
different format.
LETATWIN can only read files of
“CSV” file format or “LMF” file format.
ACCESS ERROR
Reading / writing of the card is not
implemented.
After turning off the power of
LM-380A, insert the card again.