MAX LM-380A - Manual (Page 15)

BEFORE USE
15
2-8 ADJUSTING THE HALF CUTTING DEPTH
You can adjust the half cutting depth with the ”Half cutting depth adjustment lever”, when
half cutting is too deep.
Note:
When printing on tubes, the leaver has to be
positioned on the “TUBE.”
When printing on tape, the lever has to be
positioned on the “TAPE.”
2-9 SWITCHING THE HEAD PRESSURE
You can change the strength of head pressure with the “Head pressure switching lever.”
Note: You don’t need to change the strength except the printed result is too dark.
(Changing from the standard strength to the low strength)
1. Confirm that the lever is on the standard
position.
2. Pull the lever to change the strength of the
head pressure after the lock lever is
unlocked.
3. Now, the strength of the head pressure is
low.
(Changing from the low strength to the standard strength)
1. Push the lever to change the strength of
the head pressure.
Note: Don’t change the head pressure when
the head release lever is positioned as
the figure.
Deep
Shallow
Standard position
Low position
Head release leaver
gihqp
gsrHp