MAX LM-380A - Manual (Page 34)

USING FUNCTIONS
34
6. USING FUNCTIONS
The following table shows the setting items and their default values.
SETTING ITEM DEFAULT VALUE SETTING ITEM DEFAULT VALUE
Printed material No setting TAPE: 1
Size of printed material No setting
Repeat
TUBE: 2
Character size AUTO: ON Sequence No setting
Character width STANDARD Justification CENTER
Character space STD 6, 9 mark (6_ 9_)
Line space STD Printing density 4
TAPE: 10.0 mm Cutting position 0.0mm
Pitch length
TUBE: 20.0 mm Printing alignment 0mm
TAPE: LINE LCD brightness 4
Pitch cut
TUBE: HALF-CUTTING Auto power-off YES
Vertical or horizontal HORIZONTAL Position of printing line 0
Frame NO
Printing length AUTO
Printing style of
[RPT]&[SEQ]
A: 11,22,33
Margin 2 mm Feed the head of tube YES
Note: By pressing SHIFT BS (INIT.) in [INPUT screen], all of setting items can be
returned to the default values.
The setting items of slant characters cannot be returned to the default value by initializing.
6-1 SIZE
Setting the “CHARCTER SIZE” of the line at the cursor position.
The size can be set in each line. But, the different size cannot be set in a line of the same
block.
1. Press SIZE . The [CHARACTER SIZE setting screen]
appears.
2. Press / key to select the value of the “CHARACTER
SIZE.”
3. Press key to move the cursor to “AUTO.”
Press / key to select “OFF.”
4. Press ENTER .
Note: Only when the “AUTO” is selected to “OFF”, the size setting is available.
Selectable items: “SIZE” = 2.0, 3.0, 4.0, 6.0 “AUTO” = ON, OFF
!" !" !" !"E   ` P9 P9 P9 P9 ˜3 ˜3 ˜3 ˜3
ዝዞዟ፧
P9–© ‚ ©P2 ‚ P9–© ‚ ©P2 ‚ P9–© ‚ ©P2 ‚ P9–© ‚ ©P2 ‚
j(U‰2$† j(U‰2$† j(U‰2$† j(U‰2$† k k k k$# # # #& DD DD DD DD
©†90 ©†90 ©†90 ©†90
B P
!" !" !" !"E   ` P9 P9 P9 P9 ˜3 ˜3 ˜3 ˜3
ዝዞዟ፧
P9–© ‚ ©P2 ‚ P9–© ‚ ©P2 ‚ P9–© ‚ ©P2 ‚ P9–© ‚ ©P2 ‚
j(U‰2$† j(U‰2$† j(U‰2$† j(U‰2$†)k k k k$# # # #& $DD DD DD DD
©† ©† ©† ©† )f9f )f9f )f9f )f9f
B P