Magnum Venus Plastech CB-6000-RGT Imperial units PROGRAMMING - Manual (Page 8)

7
Step 7) Pushing the Down Cursor again will change the display to look
like this:
This is the calibration number for a MVP HVLS high volume resin pump
with a resin specific gravity of 1.08 and is preset at MVP. To change this
number use the Right Cursor button and the INCREMENT/ON and
the DECREMENT/OFF buttons as described in step 4 above. See Chart
A for calibration numbers. NOTE: This is the point at which you would
normally leave the program mode and return to the run mode. To do this
simply push the RUN/PROGRAM button. Any changes that have been
made will be saved and the display will look like this:
However, if you wish to stay in the program mode pushing the Down
Cursor button will take you to step 8
Step 8) and your display will look like this:
Pushing the Right Cursor button allows you to select between high
speed or low speed (contact type) inputs. Ab. Hi is the correct setting.