beautypg.com

Magnum Venus Plastech CB-6000-RGT Imperial units PROGRAMMING User Manual

Page 6

background image

5

The following is a step-by-step procedure to change any of the operating
parameters of the meter and an explanation of what the various displays
mean.

Step 1) Turn the front panel power switch off.


Step 2) Connect power (100 to 125 VAC, 50/60 Hz, 6 VA) to the unit and turn
the power switch on. The initial rate meter display should look like this:


Step 3) Push the RUN/PROGRAM button. The display should now look
like this:


This indicates that you are now in the "Program" mode and are now able to
change the decimal point reading on the unit's display. Pushing the Right

Cursor button will change the decimal point to as many as 4 places
(.0000) or no places (0). It is recommended that a 1 place decimal (.0) be
used.


Step 4) Push the Down Cursor button and your display should now
look like this: