Magnum Venus Plastech CB-6000-RGT Imperial units PROGRAMMING User Manual
Page 7
6
This number is the high limit for an alarm function. When the display
reaches this number (or greater) a connection is made inside the unit and a
.5 VDC current is available at the output terminals at the rear of the unit. To
change this value, push the Right Cursor button and the first digit will
be highlighted. By pushing the INCREMENT/ON or the
DECREMENT/OFF buttons you can increase or decrease the value of
the highlighted digit. Pushing the Right Cursor button will move the
highlighted digit to the right. This value is normally left at 0000.0.
Step 5) Push the Down Cursor button again and the display will change
to this:
This is the low limit for the alarm function. The setting procedure and the
preferred setting are the same as in step 4 above.
Step 6) Push the Down Cursor button again and the display will change
to this:
You can now set the decimal point position for your calibration number.
Normally a 3 place decimal is satisfactory but if you have a calibration
number that is less than 10 (see chart) change this to a 4 place decimal by
using the Right Cursor button to increase or decrease this decimal
point.