Magnum Venus Plastech DP-1000 (EPO3) - Manual (Page 9)

(Figure 1. Front Panel Controls)
Turn off all front panel switches.
Turn all regulators to “0” (zero) or fully counterclockwise.
Turn off MAIN PRESSURE to unit. Check that heater indicator on the front panel is OFF (do not activate
heaters).
Front Panel Controls
Each control on the front panel is described in the following:
The HEAT indicator, on the left and right sides of the control panel, shows when the heaters are ON or
OFF. When the HEAT is on the lens turns green.
TEMP gauges indicate what the temperature is for the materials in the hoses.
MAIN PRESSURE switch turns on the pump that applies pressure to the materials.
MAIN PRESSURE gauge indicates how much pressure is being applied to the materials.
MAIN PRESSURE regulator allows you to vary the pressure applied to the materials.
FLUSH PRESSURE switchturns on the flushing system in the unit.
FLUSH PRESSURE gauge indicates pressure when the unit is being flushed.
FLUSH PRESSURE regulator varies the solvent system pressure.
RECIRCULATION PRESSURE switch allows the materials to be cycled through the unit without being
output from the gun-head. The gun trigger is in the middle position during recirculation mode.
RECIRCULATION PRESSURE gauge indicates what the pressure is when the unit is in recirculation
mode.
RECIRCULATION PRESSURE regulator varies the recirculation pressure.
PRE-HEAT button is pushed and held in for the period of time it takes for the heater block to warm up.
BLOCK HEAT switches allow you to select LOW, OFF, or HIGH temperature for the block heaters.
LINE HEAT switches allow you to select LOW, OFF, or HIGH temperature for the line heaters.
Unit Side Panels
The location of the connections and hoses for the INLET and OUTLET PANELS are shown in
Figures 2 and 3.
Inlet Panel
POWER SUPPLY connection
RESIN RETURN HOSE
RESIN SUPPLY
HARDENER PUMP RELIEF valve
(“PUMP H”).
HARDENER RETURN HOSE
HARDENER SUPPLY
AIR INLET