Aiphone FK1629 User Manual
Page 19
19
GETTING STARTED
USING THE SYSTEM
APPENDIX
SETTING AND ADJUSTMENT
F
Setting the PRIVACY function [PRIVACY]
Setting of the PRIVACY function is available when called from
another master station.
When the PRIVACY MODE is activated, the microphone turns
off and you will not be heard by the caller.
Sub item
Description
Setting range
[PRIVACY MODE] Sets whether or not to
activate the PRIVACY
function. To activate
the PRIVACY function,
select the PRIVACY
MODE 1 or 2.
(PRIVACY MODE) 1:
The microphone is off
(mute).
(PRIVACY MODE) 2:
The microphone is off
(mute) and the caller
and you are notifi ed by
a tone when you receive
the call that you are in
the PRIVACY MODE.
OFF:
The microphone is on.
[PRIVACY-2 CALL
TONE]
(Available when
(PRIVACY MODE) 2 is
selected.)
1-6
Selects the call tone
from 6 types.
Press
1
repeatedly to select [PRIVACY] (so that
it is highlighted), and then press ZOOM/WIDE to
select.
The sub items are displayed.
The sub items can also be displayed by pressing
*
PRIVACY
in the standby mode.
Press
2
repeatedly to select the sub item
[PRIVACY MODE] or [PRIVACY-2 CALL TONE] you
wish to set (so that it is highlighted), and then press
ZOOM/WIDE to decide on the selected one.
Make the settings on each sub item as follows.
3
[PRIVACY MODE]:
Press
repeatedly to select the desired mode (so
that it is highlighted), and then press ZOOM/WIDE to
decide on the selected one.
When (PRIVACY MODE) 1 or (PRIVACY MODE) 2 is
*
selected, the LED on
PRIVACY
lights up (red).
[PRIVACY-2 CALL TONE]:
This setting is available only when [PRIVACY MODE] is set
*
to (PRIVACY MODE) 2.
Press
repeatedly to select the desired call tone,
and then press ZOOM/WIDE to decide on the selected
one.
You can check the selected tone by hearing it whenever
*
selected.
G
Initializing the set contents [INITIALIZATION]
You can reset all the set contents to default.
Press
1
repeatedly to select [INITIALIZATION] (so
that it is highlighted), and then press ZOOM/WIDE
to select.
“RETURN TO DEFAULT ?” is displayed.
Press
2
ZOOM/WIDE to continue the initialization
procedure.
Press
3
repeatedly to select [YES] (so that it is
highlighted) to perform initializing, and then press
ZOOM/WIDE to select.
Select [NO] if you will cancel initialization.
*
NOTE:
If you have repositioned the master station, initialize it to clear the
speed dial settings etc., and make the settings again.