CNB SSM2065PW - Manual (Page 6)

Xpeed Mini Outdoor Speed Dome Camera Series
www.cnbtec.com 11
„ Termination Switch Setting
Termination switch(Pin 4) is used in cases listed below.
z Long-distance communication between the controller and the
camera (1-to-1 connection)
When the connecting distance between the two units is especially long,
communication errors may occur due to the impedance of transmission
cable. In this case, set the termination switch of both units to ON.
z Controlling multiple cameras (Multiple connection)
The camera may not operate correctly if multiple cameras are connected
and controlled. In this case, set the termination switch of the controller
and the last connected camera to ON and the switch of other cameras is
OFF.
Ex) Using the Terminating Resistance
2. INSTALLATION
Xpeed Mini Outdoor Speed Dome Camera Series
www.cnbtec.com 12
▣ Installation of Mount Gasket
① Pull out the rounded
rubber rubber tube.
② Make a incision in the
(+) form at the upper
part of the rubber tube.
③ Have the cables run
through the rubber tube
as illustrated on the
picture.
④ Tie up the rubber
tube in the middle.
⑤ Assemble the gasket to
the bracket and
complete the installation
after put the tied tube
back to the orginal
position.
2. INSTALLATION