CNB SSM2065PW - Manual (Page 10)

Xpeed Mini Outdoor Speed Dome Camera Series
www.cnbtec.com 19
▣ Preset
z Function Max. 127 positions can be stored as Preset position. The Preset number can be assigned
from 1 to 128, but 95 is reserved for starting OSD menu.
Camera characteristics (i.e. White Balance, Auto Exposure) can be set up independently
for each preset. Label should be blank and "Camera Adjust" should be set to "GLOBAL"
as default. All characteristics can be set up in OSD menu.
z Set Preset [1~128]
z Run Preset [1~128]
z Delete Preset To delete Preset, use OSD menu.
▣ Swing
z Function By using Swing function, you can make camera to move between 2 Preset positions
repeatedly. When swing function runs, camera moves from the preset assigned as the 1st
point to the preset assigned as the 2nd point in CW(Clockwise) direction. Then camera
moves from the preset assigned as the 2nd point to the preset assigned as the 1st point in
CCW(Counterclockwise) direction.
In case that the preset assigned as the 1st point is same as the preset assigned as the 2nd
point, camera turns on its axis by 360° in CW(Clockwise) direction and then it turns on its
axis by 360° in CCW(Counterclockwise) direction. Speed can be set up from 1°/sec to
180°/sec.
z Set Swing To set Swing, use OSD menu.
z Run Swing Method 1) [Swing NO.+10]
Method 2) [Swing NO + 140]
ex) Run Swing 3 : [13]
ex) Run Swing 3 : [143]
z Delete Swing To delete Swing, use OSD menu.
3. OPERATION
Xpeed Mini Outdoor Speed Dome Camera Series
www.cnbtec.com 20
▣ Pattern
z Function Pattern Function is that a camera memorizes the path (mostly curve path) by joystick of
controller for assigned time and revives the path exactly as it memorized.
4 Patterns are available and Maximum 1200 communication commands can be stored
in a pattern.
z Setting Pattern Pattern can be created by one of following two methods.
Method 1) [Pattern NO.]
z Pattern editing screen is displayed as bellow.
z Movement by Joystick and preset movement can be memorized in a pattern.
z The rest memory size is displayed in progress bar.
z To save the recording, press NEAR key and to cancel, press FAR key.
Method 2) OSD Using OSD Menu: See the section “How to use OSD Menu”.
z Run Pattern Method 1) [Pattern NO.]
Method 2) [Pattern NO+130]
ex) Run Pattern 2 : [2]
ex) Run Pattern 2 : [132]
z Delete Pattern To delete Pattern, use OSD menu.
3. OPERATION