Clear-Com V12PDDXY - Manual (Page 3)

. V-Series XLR-7M Option
are located on the rear of the panel and one at each end of the panel (Figure
3). Ensure that all the screws are retained for refitting the lid.
Figure 3: Remove Screws from Panel Lid
Remove the lid from the panel.
Step 3
If the panel is a 1-RU panel then the front panel assembly must be removed to gain
access to change the headset connector. If the panel is a 2-RU panel then the front
panel assembly need not be removed.
If the front panel does not need to be removed omit steps 4 and 5.
Step 4
Remove the 2 encoder knobs from the Main and Aux level controls. These simply pull
off the shafts.
Remove the countersunk screws from the rear of the left and right mounting ears.
Figure 4: Mounting Ears on 1-RU Panel
3 PN 810405Z Rev. C