Clear-Com V12PDDXY - Manual (Page 16)

V-Series XLR-7M Option .
Appendix A Headset Connector Assembly Adjustment
In order to align the PCB correctly with the block the grubscrew should be loosened
before adjusting the Headset Connector Assembly. This is done by turning the
grubscrew anticlockwise to loosen the PCB from the block.
Figure 23: Grubscrew in Headset Connector Assembly
Adjust the PCB position to centralize the curved PCB edges with respect to the holes
in the block and then retighten the grub screw by turning it clockwise.
Warning: The grub screw in the XLR connector has a left hand thread; when
this is turned clockwise the grub screw will move out of the connector and lock
with the black plastic moulding. Do not over tighten the grub screw as this is
very difficult to refit once the PCB is assembled.
Figure 24: XLR-7M Assembly Alignment
PN 810405Z Rev. C 16 .