Clear-Com V12PDDXY - Manual (Page 15)

. V-Series XLR-7M Option
Step 5
Figure 22: XLR-7M Headset Connector Assembly with Audio Card Cable
Replace the front panel assembly ensuring it is replaced in the correct
orientation noted in step 1, making sure that the correct screws are used (see
Figure 18).
Insert the microphone connector edge into position first, then lower the
headset connector into place.
Note: Ensure that no cables are trapped before attempting to refit the
screws.
Apply pressure to the lid to align the screw holes and fit the top and bottom
screws loosely on each side before fitting the remaining screws and tightening
all the screws.
Re-site the panel and reconnect power and I/O cables.
15 PN 810405Z Rev. C