Clear-Com RS-603 (No longer available) - Manual (Page 7)

R S - 6 0 3 / 6 2 3 / R B E L T P A C K S 5
QUICK START
To start using your beltpack immediately:
1. Connect the appropriate 3-pin XLR line cables from an
active TW intercom line to the beltpack.
2. Turn down the beltpack’s incoming volume on each intercom
channel with the channel A and channel B volume-control
knobs.
3. Plug in a headset to the beltpack’s connector labeled
“headset.”
4. To talk on an intercom channel, press and hold the talk
button for the desired channel. Speak into the microphone in
your headset.
Note: If you tap the talk button twice in quick succession, the
talk button locks to the “on” setting (“latches”) for hands-free use.
Press the talk button again to unlatch it. RS-603R and
RS-623R models initially power up in RTS-mode, in which a
talk button latches with a single tap. You can change this setting
with onboard controls or with the V-Pack software. See the
chapter “Customizing Your Beltpack” later in this manual for
information on programming a beltpack.