Clear-Com RS-603 (No longer available) - Manual (Page 21)

1 9 R S - 6 0 3 / 6 2 3 / R B E L T P A C K S
CONNECTING THE BELTPACK
A beltpack connects to the intercom line by connecting to a main
station, power supply, or another beltpack. You must also connect a
headset to the beltpack and, optionally, a computer for programming
beltpack options with the V-Pack software.
The following table lists the connectors for the RS-603 series of
beltpacks. Figure 5 illustrates the connectors for an RS-603 beltpack
Table 1: Connectors for RS-603 Series of Beltpacks
Intercom Connector / Loop-Through Connector
Figure 1 illustrates the “intercom” and “loop-through” connectors on
an RS-603 beltpack. The beltpack connects to a main station, power
supply, or to other beltpacks with the connector labeled “intercom.”
The “loop-through” connector connects the beltpack to the intercom
line or to another beltpack (“looping through”).
CONNECTOR RS-603 RS-623 RS-603R RS-623R
Intercom 3-pin F 3-pin F 3-pin M 3-pin M
Loop-through 3-pin M 3-pin M 3-pin F 3-pin F
Aux headset 2.5 mm 2.5 mm 2.5 mm 2.5 mm
Headset 4-pin M 6-pin M 4-pin F 5-pin F
1