General information, Application conditions, Operating conditions 5.2. installation conditions – Burkert Type 6144 User Manual
Page 7
7
07 ATEX 2048
English
General information
4. GENERAL INFORMATION
4.1. Contact address
Germany
Bürkert Fluid Control Systems
Sales Center
Chr.-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: [email protected]
International
Contact addresses can be found on the final pages of these oper-
ating instructions.
And also on the internet at:
4.2. Warranty
The warranty is only valid if the device is used as authorized in accor-
dance with the specified application conditions.
4.3. Information on the internet
Operating instructions and data sheets for the flipper valve type 6144
can be found on the internet at:
5. APPLICATION CONDITIONS
The flipper valve type 6144 is designed for the use in roof-covered
areas. Do not use the valve in outside areas.
5.1. Operating conditions
When operating the single valve type 6144, the following require-
ments have to be observed.
5.1.1. Application temperature range:
For the application temperature range, the permissible
values for the flipper valve apply, which are listed in the
chapter "Technical data".
5.1.2. Max. permissible ambient temperature
The maximum permissible ambient temperature is
dependent on the energy fed in, the temperature class and
the installation.
The corresponding values are listed in the chapter "Tech-
nical data".
5.2. Installation conditions
The suitability of the valve for single or block installation is dependent on
the energy fed in, the temperature class and the ambient temperature
(see "Technical data").
Also follow the instructions in the chapter „Assembly / instal-
lation“ and „Start-up“.