Burkert Type 6606 User Manual
Page 8

28
Ensure that the seal is fitted correctly for the
electrical connection to the cable plug.
NC
N0
Cable plug
Type 2506
Seal
Valve
max. tightening
torque: 0.4 Nm
note!
If the tightening torque is too great, the device may
be damaged!
Observe the maximum tightening torque of the screws!
•
Screw cable plug to the valve at a maximum tightening
→
torque of 0.4 Nm.
english
29
mainTenance,
9.
TrOubleshOOTing
The valve is maintenance-free under normal operating
conditions.
safety instructions
9.1.
Danger!
Risk of injury from high pressure in the equipment!
Before loosening the lines and valves, turn off the
•
pressure and vent the lines.
Risk of injury due to electrical shock!
Before reaching into the device or the equipment,
•
switch off the power supply and secure to prevent
reactivation!
Observe applicable accident prevention and safety
•
regulations for electrical equipment!
english
29
30
Warning!
Risk of injury from improper maintenance!
Maintenance may be carried out by authorized techni-
•
cians only and with the appropriate tools!
Risk of injury from unintentional activation of the
system and an uncontrolled restart!
Secure system from unintentional activation.
•
Following maintenance, ensure a controlled restart.
•
english
31
maintenance Work
9.2.
Malfunctions
If malfunctions occur, check
the port connections: the correct configuration of the
→
fluid connections according to the circuit functions (see
chapter entitled “
8.2. Fluid Installation”)
whether the operating pressure is within the permitted
→
range.
the power supply and valve control
→
the location of the coil seal: the seal must not cover the
→
metallic areas of the coil.
Coil seal
If the valve still does not switch, please contact your
Bürkert Service.
english
31
Type 6126 / 6606