eLine Technology EPTZ-27DN User Manual - Manual (Page 5)

Operation Manual ELI-EPTZ-27DN eLineTechnology.com
4
concrete position shooting by the camera)
 Auto enter function running after self-test of the dome device and auto enter
function running when there is no transmission.(Dwell time can be set from 5 to 999 seconds)
 Freeze video picture function.(frozen picture function)
 Operation return function.(after executing operation return, the dome device will
return to the previous operation)
 Intelligent manual scan function.(execute this function in manual pan operation, you
can adjust the manual pan operation)
 Intelligent power off real time memory.(If power is cut off when a certain function is
in operation, the dome device can resume working at where the power is cut off.)
 High efficient 3-dimension scan.
 Camera zoom in speed limit function.(When it is zooming in, the speed
of the dome device will auto slow down.)
 Remote setting of dome address.
Chapter 2 Menu setting
2.1 Operation instructions
Menu operation instruction
To make a selection, move the joystick in the Up or Down direction. The on-screen arrow
points to the selected option. Using the joystick to the Left or Right position you can change the
value of your selection or enter the submenu for the selected option. Press the button CLOSE on
the keyboard controller to exit the menu or return to the previous menu(one layer up)
Number setup.
 Joystick Left or Right when programming to select preset.
 Press OPEN to confirm, open and display the number selection cursor
 Joystick Left or Right to select the number to be entered
 Press OPEN to confirm selection. The selected number is displayed on the
corresponding data bit.
 Number of respective data bits are input as above.
 Press CLOSE to exit or return to the previous menu level when programming is
done.