eLine Technology EPTZ-27DN User Manual - Manual (Page 24)

Operation Manual ELI-EPTZ-27DN eLineTechnology.com
23
Call Preset point:
Press “No.” + “Shot” + “ACK”.
Clear Preset point:
Press “No.” + “Shot” + “OFF”.
2. Description of “cruise track” function:
 When enter “51+SHOT+ON”, the device is enabled system default cruise track. The
device will auto scan point by point from No.1 preset position to No.16 preset position.
If certain position has not been preset or been cleared after preset, “cruise track” will
not scan them.
 Dwell time of the preset position is 2 seconds.
 About other 6 cruise tracks operation, please refer operation manual of the keyboard
controller. Different controller is with different operation.
3. Description of “Line-Scanning” function:
 Dome device will auto line-scan between two specified points.
 User can set the start point by “52+SHOT+ON” and end point by “53+SHOT+ON”.
 Line scanning speed set: user keep a manual line scan speed three seconds above,
then through“51+SHOT+ACK” to save the speed as line scan speed,
use“52+SHOT+ACK” to enable the line scan.
 Dwell time of line-scanning between “starting point” and “ending point” is 2 seconds.
4. Intelligent manually pan continuous scan:
 When user use joystick for pan scan monitoring, keep manually 3 seconds, then
press“101+SHOT+ACK”, the dome can go on with the scan speed and monitor
position automatically .