eLine Technology EPTZ-27DN User Manual User Manual

Page 16

Operation Manual ELI-EPTZ-27DN eLineTechnology.com

2.7.3 Pattern

Function: User can program three traces simulating manual operation.

FUNCTION PROGRAMMING

1 PRESET

2 VECTORSCAN

3 PATTERN

4 SECTOR SETUP

5 MASK ZONE

6 MASK COLOR

7 MOTION

PATTERN

Pattern Operation Steps:

[1].Joystick Up/Down to move the

cursor to select Pattern.

[2].Joystick Left/Right or press OPEN

to enter the menu.

[3].Joystick Up/Down to select pending

operating or programming

Pattern(number range:1～3).

[4].Joystick Up/Down to move the cursor

to select Program a Pattern.

[5].Press OPEN to enter recording of the

manual running trace .as left Fig 1.

[6].Press CLOSE to finalize the

selection. as left Fig 2.

[7].Joystick Up/Down to move the cursor

to select NAME.

[8].Edit name (Please refer to name

setting section of preset position)

PATTERN

1 NUMBER 1

2 PROGRAM A PATTERN

3 RUN A PATTERN

4 DELETE A PATTERN

5 NAME ______

6 NAME DISPLAY OFF

IRIS OPEN TO BEGIN

IRIS CLOSE WHEN DONE

Fig 1

Fig 2

[9]. Joystick Up/Down to move the cursor to select Name Display.

RUN A PATTERN

Running Pattern Tracking Operation Steps:

[1].Select pending running Pattern trace from NUMBER.

[2].Joystick Up/Down to select Run a Pattern.

[3].Joystick Left/Right or press OPEN to run the trace of selected Pattern.