CEMB USA DWA 1000XLB - Manual (Page 57)

I 0645 58 GB
The camber tends to always have the same sign
Car lift or fl oor not suffi ciently
levelled
Level the car lift according to the following tolerances:
- Maximum difference in height between two wheels
along the wheelbase or track of the vehicle: 1 mm
- Maximum difference in height between two wheels
along the diagonal of the vehicle: 1.5 mm
This screen appears
Beams interrupted by the
operator getting in the way Free the visual range of the infrared beams
Lateral rays interrupted by
interposition of an
irremovable obstacle Activate the procedure that allows you to adjust when
the rays are interrupted
Chapter 9.8
Execute 3x90 runout Chapter 6.4
Front or rear beams interrupted
by the vehicle getting in the way Activate the Spoiler procedure see chapter 12.1
CCD sensor blinded by the sun Put the CCD sensor in the shade
On the road the vehicle "pulls" to one side
Tyres differently worn Replace the tyres or try and fi t the rear ones at the front
and vice versa
If the "pulling" direction varies
accelerating or decelerating
Play in the suspension
Replace the parts with play
Humpbacked road This is not a defect
Right caster or camber greatly
different from the left Equalize the caster or the camber
Negative caster Make the caster positive