CEMB USA DWA 1000XLB - Manual (Page 3)

I 0645 3 GB
T
HIS MANUAL FORMS AN INTEGRAL PART OF THE PRODUCT AND ITS PURPOSE IS TO PROVIDE USERS WITH THE NECESSARY
OPERATING INSTRUCTIONS FOR THE WHEEL ALIGNER . C AREFULLY READ THE MANUAL BEFORE USING THE WHEEL ALIGNER AND
EACH TIME YOU NEED TO OPERATE ON THE MACHINE . K EEP IT IN AN ACCESSIBLE PLACE FOR THE ENTIRE OPERATING LIFETIME
OF THE MACHINE . A NY DAMAGE DERIVING FROM FAILURE TO OBSERVE THE INSTRUCTIONS CONTAINED IN THIS MANUAL AS WELL
AS FROM IMPROPER USE OF THE MACHINE RELIEVES THE MANUFACTURER OF ALL RESPONSIBILITY .
General warnings
The manual refers to the essential requirements set out in the directives, standards and provisions
pertaining to use of the machine summarising the most signifi cant points.
In addition to the service instructions, the general rules of law and the binding rules regarding the
prevention of accidents and protection of the environment must be observed.
For all the work to be carried out with or on the machine, the following provisions must be complied
with as well as the general safety regulations following the instructions.
The user must ensure that the machine is always and only used in perfect condition taking into
account the essential safety requirements and the applicable regulations.
The machine must immediately be put out of service if any defects or malfunctioning is found.
Only trustworthy persons may work with the machine; the user is responsible for ensuring that the
persons assigned to the job are suitably qualifi ed and trained.
For any doubts about use and maintenance of the machine, consult this manual; if necessary,
contact the authorised technical service centres.
Precautions and instructions for safety, use and maintenance
The data plate bearing the voltage and frequency data is affi xed on the rear of the machine.
NEVER CONNECT THE MACHINE TO A VOLTAGE OR FREQUENCY OTHER THAN THOSE INDICATED.
The machine is equipped with a 3-wire plug with incorporated earth to be inserted only in an
earthed socket. If it is not possible to fi t the plug in a socket of this kind, please consult an
electrician.
Do not modify or improperly use the plug.
This machine is not equipped with a manual power cutting device. To cut the power, pull out the
plug or turn off the main switch positioned upstream.
All the operations on live electrical parts must be performed after turning off the power switch on
the electric cabinet.
Do not remove or make unrecognizable the danger warning plates, adhesive labels and markings on
the machine and
make sure that they are always legible.
All the maintenance and inspection operations must exclusively be carried out by qualifi ed persons.
Mechanical and electrical repairs as well as setting operations may only be carried out by qualifi ed
persons.
Unauthorised persons must be prohibited from performing any work on the machines and equipment
of the system.
In the event of signifi cant faults that may compromise the safety and/or reliability of the machine,
it must be stopped and in any case not started before the faults have been corrected.
It is prohibited to transform or make modifi cations to the electric system.
The user will be held responsible for any damages as a result of such modifi cations. In case of doubt,
please contact the manufacturer before making any modifi cations.
Exclusively use original fuses with the specifi ed capacity in ampere! In the event of electrical power
supply faults, the machine must immediately be turned off.
Defective fuses may not be repaired or deactivated, but must be replaced with fuses of the same
type.
Comply with the environmental protection regulations when disposing of waste substances or
replaced parts.
CAUTION!