CEMB USA DWA 1000XLB - Manual (Page 20)

I 0645 21 GB
5.2 - Ride height
To access this page, press from the Vehicle Specifi cations page
The Ride Height page allows:
Viewing which measurements on the vehicle are required by the manufacturer (ride height or inclination •
of parts of the suspension) and if necessary enter the results.
Viewing which measurements to check on the vehicle before making the measurement and the
•
adjustment (e.g. chassis height or component tightening torque)
Viewing which special tools to apply (e.g. toe-in bar)
•
Vehicle 1.
Images of the measurements to be made on the vehicle or the tools to be applied. Examples: 2.
a. Position the toe-in bar
b. Measurements with rule
c. Measurements with inclinometer
Tables 3.
Once the tools have been applied and the measurements made, consult the tables.
If they indicate that you need to check that the measurement is within a certain tolerance interval and •
this is not the case, act on the vehicle adjustments to bring the measurements within tolerance.
If they indicate that you need to enter the measurement made, select the row from the corresponding
•
table. The vehicle specifi cations are modifi ed as a result.
You are advised to follow the manufacturer's indications; if it is required to set the
measurement and this is not done, average values are used for the specifi cations.
: Selects one of the two tables
: Selects the value of the measurement made on the vehicle (used only
for tables that indicate that the modifi cation selected must be entered)
: Goes back to the Vehicle Specifi cations page, if necessary changing
the values of the vehicle angles based on the measurements made