CEMB USA C202 - Manual (Page 15)

I 0592 - 15 GB
5.5 - Result of measurement ►
After performing a balancing spin, the unbalance values are displayed as well as arrows useful for positioning the
point of application of the correction weight. After positioning the wheel, apply the weight in the 12 o’clock position.
When the acoustic beep is enabled (
ACOUSTIC SIGNAL
), reaching of the correction position is indicated by a
“beep”.
If the unbalance is less than the chosen threshold value, the “OK “ message appears instead of the unbalance value
to indicate, on that particular side, the wheel is in tolerance; the residual unbalance can be displayed by pressing
button with an accuracy of 0.5 g (0.1 oz).
The following buttons are enabled:
Display of residual unbalance
Selection of correction mode (DYNAMIC, STATIC, ALU). When the mode is changed, the unbalance
values are recalculated automatically on the basis of the previous run, ( ALU AND STATIC MODES ).
Eccentricity measurement graph (option).
1)The symbol above the key is displayed in red if the fi rst harmonic eccentricity exceeds the
recommended minimum limit (1.2 mm for vehicles, 3.0 mm for trucks).
2) Holding this button down for more than 1.5 seconds, eccentricity measurement is temporarily
disabled (enabled in
GENERAL SETUP ). To re-enable eccentricity measurement, again hold down the
button for more than 1.5 seconds. Each time the machine is switched on, the state of eccentricity
measurement refl ects what has been set in GENERAL SETUP.
Car/truck selection
Unbalance split control for presettable components (
“SPLIT” CONTROL
). Button only enabled in STATIC
or ALU correction
Indication of the longitudinal position of the unbalance (
INDICATION OF EXACT CORRECTION WEIGHT
POSITION
) is enabled
Selecting special functions
Balancing run.
If the machine remains on this screen without being used for more than the time preset in the
Setup parameters (6), the screen automatically returns to the screen-save.
Correction on inside Correction on outside