CEMB USA C202 - Manual (Page 12)

I 0592 - 12
7
d
b
a
GB
5.3.2 - Manual presetting
5.3.2.1 - Standard wheels
►
►
If necessary, the dimensions can be inserted or edited in manual mode as follows:
- press + or else press from the Dimensions screen in automatic mode (which can
be reached by pulling out the distance + diameter gauge).
- press to select the dimension to be preset (highlighted in red).
- press / to preset the required value.
- press to change unit of measurement.
- press to switch to the Manual Presetting screen for the ALU dimensions
- press to return to the Measurements screen
Defi nition of dimensions:
d = DIAMETER: Preset the nominal diameter stamped on the rim.
b = WIDTH:
Preset the nominal width indicated on the rim.
a = DISTANCE: Preset the distance of the inside of the wheel from the machine measured with special gauge as
described
in fi g. 7.