CEMB USA C202 User Manual
Page 11
I 0592 - 11
5
6
6a
GB
The calibration performed as such is necessary for modes ALU, Static, Dynamic.
Manually presetting is possible by using the push buttons as described in
MANUAL PRESETTING
.
N.B.
Depending on the preset diameter, the machine is automatically set to truck mode (diameter
≥ 18”
or 450 mm) or car mode. However such selection can be changed at any moment in the
Measurement screen (
RESULT OF MEASUREMENT
).
The enabled buttons are:
decrease
width
increase
width
car/truck
selection
select the dimensions presetting in manual mode screen
return
to
initial
frame
launch
balancing
5.3.1.2 - Wheels ALU
After the measurement performed for the FI inner side, as indicated in fi g. 6, pull out the gauge again to store the
data for the FE outer side (fi g. 6a); hold the position for at least 2 seconds until the counterweight symbols change.
colour. When the acoustic signal is enabled (see
ACOUSTIC SIGNAL
), the acquisition is accompanied by a “beep”.
►
ALU inside
ALU outside