PA Industries Edge Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 25)

ULTRA EDGE SERVO ROLL FEED 2/14/ 2003
25
T o o l # 1
S a v e
S a v e a s <
T O O L S - n e x t B K S P - P r e v
T o o l # 1
D e l e t e T o o l <
T O O L S - n e x t B K S P - P r e v
Press “ENTER” key.
D e l e t e T o o l # 1
P r e s s 1 t o c o n f i r m
A n o t h e r k e y t o a b o r t
Press “1” key.
T o o l # 1 D e l e t e d
4.5 HOW TO ACTIVATE A TOOL
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position. If the current screen is one of the setup screens (they all have message on the last line “ Press
“SETUP” for next”), press the “OPER” key to exit setup screens.
Press “TOOLS” key, position the pointer next to Activate tool command and press the “ENTER” key.
E d i t T o o l
A c t i v a t e T o o l <
C r e a t e N e w
P r e s s T O O L S t o e x i t
A c t i v a t e T o o l #
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t
Enter desired tool number or select it from the tool list using “ ↑” and “↓” keys and press the “ENTER” key again.
A c t i v a t e # 1 2 3 4 5 6 7
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t
T o o l A c t i v a t e d