PA Industries Edge Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 23)

ULTRA EDGE SERVO ROLL FEED 2/14/ 2003
23
Press “TOOLS” key to open next screen. To save changes as a new tool, choose the SAVE AS command and press
the “ENTER” key.
T o o l #
S a v e
S a v e a s <
T O O L S - n e x t B K S P - P r e v
Enter the new tool number and press the “ENTER” key again.
S a v e a s T o o l #
P r e s s T O O L S t o A b o r t
S a v e a s # 5
T o o l # 5 S a v e d
4.4 HOW TO DELETE A TOOL
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position. If the current screen is one of the tool editing screens (they all have message on the last line “ Press
TOOLS for next”), press the “OPER” key to exit tool editing.
Press “TOOLS” key, position the pointer next to EDIT TOOL command and press the “ENTER” key.
E d i t T o o l <
A c t i v a t e T o o l
C r e a t e N e w
P r e s s T O O L S t o E x i t
Enter desired tool number or select it from the tool list using “ ↑” and “↓” keys and press the “ENTER” key again.
E d i t T o o l #
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t
E d i t T o o l # 1
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t