PA Industries Edge Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 16)

ULTRA EDGE SERVO ROLL FEED 2/14/ 2003
16
NOTE: To exit setup editing at any time, press the “OPER” key. Changes will be saved.
4 HOW TO …
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position. If the current screen is one of the tool editing screens (they all have the message on the last line “Press
TOOLS for next”), press the “OPER” key to exit tool editing.
4.1 HOW TO CREATE A NEW TOOL
Press the “TOOLS” key.
Position the pointer next to Create new tool command and press the “ENTER” key.
E d i t T o o l
A c t i v a t e T o o l
C r e a t e N e w <
P r e s s T O O L S t o E x i t
Enter new tool number and press the “ENTER” key again.
C r e a t e T o o l #
P r e s s T O O L S t o E x i t
C r e a t e # 1
LINEAR
ACCELERATION
S-CURVED
ACCELERATION