PA Industries Edge Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 12)

ULTRA EDGE SERVO ROLL FEED 2/14/ 2003
12
NOTE: Up to 200 tools can be saved.
T o o l #
S a v e <
S a v e a s
T O O L S - n e x t B K S P - P r e v
Use SAVE to save the tool being edited. Press the “ENTER” key.
T o o l # 1 S a v e d
Use SAVE AS to create a new tool using the one being edited. Press the “ENTER” key, enter desired tool number,
and press the “ENTER” key again.
S a v e A s T o o l #
P r e s s T O O L S t o A b o r t
S a v e A s # 1 2 3 4 5 6 7
T o o l # 1 2 3 4 5 6 7 S a v e d
The display will show the STATUS screen.
T o o l # 1 S p d : 3 8 4
A u t o M o d e
3 0 / C o n t . R u n
P r e s s a M o d e K e y
If saving is skipped, then the next screen allows deleting the tool being edited. Press “TOOLS” to open it. Press the
“ENTER” key, the warning message will be displayed, press “1” key to confirm deleting or any key to abort.
T o o l #
D e l e t e T o o l <
T O O L S - n e x t B K S P - P r e v